locksmith riverside key maker

ENCLAVE REMOTE PROGRAMMING

Step-by-Step How To Programming & Memory Clearing Instructions for a 2008-2010 Buick Enclave Keyless Entry Remote Fob

Verify that this important information is on the back of your remote before using these programming instructions.

FCC ID: OUC60221 OR OUC60270

Factory Part No: 15913421, 20868672, 20952474, 22936098, 15913420, 20868852, 20669056, 22936099, 15913415, 25839476, 20859053, 25836188, 20869963, 20952477, 22936101

Programming Notes:
Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes.

You must program all existing and new remotes that you wish to use on the vehicle at this time.

Keyless Entry System Memory Clearing Instructions are noted in the dark blue colored steps below.

Procedure #1
(Vehicles with Driver Information Center Button – Located to the Right of Steering Wheel)

Step-by-Step How To Programming Instructions:
INSERT key and TURN the ignition to ON (just shy of starting vehicle without cranking engine).

PRESS vehicle information button until “PRESS TO RELEARN REMOTE KEY” is displayed.


PRESS the Set/Reset Button (Button will have a checkmark) until “REMOTE KEY LEARNING ACTIVE” is displayed.


Vehicle is now in Programming Mode.

PRESS and HOLD LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds.


An acoustic signal will sound indicating successful programming.

REPEAT Step 4 to program additional remotes.


You can have up to 8 programmed remotes for this vehicle.

You must program ALL remotes including existing remotes.

To EXIT Pogramming Mode TURN ignition OFF & REMOVE key.


Test all remotes.

Programming is now complete.

Procedure #2
(Vehicles without Driver Information Center Button)

Step-by-Step How To Programming Instructions:
INSERT key and TURN the ignition to ON (just shy of starting vehicle without cranking engine).

PRESS the Trip Odometer Reset Button until “RELEARN REMOTE KEY” is displayed.


PRESS and HOLD the Trip Odometer Reset Button for approximately 3 seconds until “REMOTE KEY LEARNING ACTIVE” displays.


Vehicle is now in Programming Mode.

PRESS and HOLD LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds.


An acoustic signal will sound indicating successful programming.

REPEAT Step 4 to program additional remotes.


You can have up to 8 programmed remotes for this vehicle.

You must program ALL remotes including existing remotes.

To EXIT Programming Mode TURN ignition OFF & REMOVE key.


Test all remotes.

Programming is now complete.

Locksmith riverside ca