locksmith riverside key maker

1997-1998 Buick Skylark Keyless Entry Remote Programming Instructions

Step-by-Step How To Programming & Memory Clearing Instructions for a 1997-1998 Buick Skylark Keyless Entry Remote Fob

Verify that this important information is on the back of your remote before using these programming instructions.

FCC ID: AB01502T, ABO1502T
Factory Part No: 16245100-29, 16207901-5, 16245104, 16245103

Programming Notes:
Obtain all remote transmitters for this vehicle.

This procedure will erase all previously programmed remotes.

You must program all existing and new remotes that you wish to use on the vehicle at this time.


Step-by-Step How To Programming Instructions:

Access programming connector in left-hand (LH) side of trunk (Driver’s side).

You may have to pull back some trim or carpet to access the programming connector.

It will have a plug on the end of it with two ports.

Use a paperclip or similar conductive wire to jump programming connector and connect the two ports.

Be sure you are making contact with the metal inside both ports.

System should now lock and unlock doors and activate trunk release to indicate successful entry into programming mode.


Press and hold Lock and Unlock buttons at the same time for up to 15 seconds.


System should now lock and unlock doors and activate trunk release to indicate successful programming of remote.

Repeat Step 4 for each additional remote to be programmed.


To exit programming mode remove jumper wire.


Test all remotes.

Programming is now complete.

Locksmith riverside ca