1996 Acura SLX Keyless Entry Remote Fob Programming Instructions

Free Step-by-Step How To Programming & Memory Clearing Instructions for a 1996 Acura SLX Keyless Entry Remote Fob

Verify that this important information is on the back of your remote before using these programming instructions.

FCC ID: Coming Soon

Programming Notes:
Obtain all remote transmitters for this vehicle.
This procedure will erase all previously programmed remotes.

You must program all existing and new remotes that you wish to use on the vehicle at this time.

Step-by-Step How To Programming Instructions:
REMOVE the Dashboard panel located to the left and below the steering wheel in order to access the keyless entry system receiver module.

TURN the vehicle’s Ignition to ON (just shy of starting vehicle without cranking engine).

LOCATE the Green keyless entry module Programming Button on the keyless entry system receiver.

PRESS the Green Programming Button until the exterior lights OR the LED light on the Driver’s side dashboard illuminate signalling that the vehicle has entered Programming Mode.

Within 5 seconds of Step 4 PRESS and RELEASE the top button on the remote. The dash LED light will turn OFF, the vehicle horn will chirp and the front marker lights will flash to signal successful programming of the remote.

REPEAT Steps 4 and 5 to program any additional remotes.

TURN the Ignition to OFF and replace the Dashboard panel. 

Test all remotes.

Programming is now complete.